Alto-Shaam 1767-SK handleiding
Handleiding
Je bekijkt pagina 16 van 44
MN-29756 (Rev. 4) 10/16 • TH-SK Series Cook, Hold, Smoke • 14
The appliance must be installed by a qualified service
technician. The oven must be properly grounded in
accordance with the National Electrical Code and
applicable local codes.
Plug the unit into a properly grounded receptacle
only, positioning the unit so that the plug is easily
accessible in case of an emergency. Arcing will occur
when connecting or disconnecting the unit unless all
controls are in the “off” position.
Proper receptacle or outlet configuration or
permanent wiring for this unit must be installed by
a licensed electrician in accordance with applicable
local electrical codes.
Cook & Hold, and Smoker models at 208-240V are
dual rated units with a conversion switch mounted
under an access cover on the rear of the oven, near
the power cord.
With the voltage conversion switch in the 200-208V
(upper) position, the oven will function properly with
a source voltage of between 200 and 208.
With the voltage conversion switch in the 220-240V
(lower) position, the unit will function properly with
a source voltage of between 220 and 240.
NOTICE: All 208-240V units are shipped from the
factory with the voltage conversion switch
in the 220-240V position.
All 125V rated units will function properly with a
source voltage of between 100 and 125, 60 Hz.
The 125V rated units are provided with a cord and
plug [NEMA #5-20P]. Have a licensed electrician
install the proper outlet configuration as required
for the unit in accordance with applicable, local
electrical codes. This will assure a safe and trouble-
free installation.
ELECTRICAL CONNECTION
INSTALLATION
WARNING
To prevent serious injury, death, or
property damage:
All electrical connections must be
made by a qualified and trained service
technician in accordance with applicable
electrical codes.
This appliance must be adequately
grounded in accordance with local
electrical codes or, in the absence of local
codes, with the current edition of the
National Electrical Code ANSI/NFPA No.
70. In Canada, all electrical connections
are to be made in accordance with CSA
C22.1, Canadian Electrical Code Part 1 or
local codes.
CE-approved appliances include an
equipotential-bonding terminal marked
with the symbol shown on the le .
Provisions for earthing are to be made in
accordance with IEC:2010 60335-1 section
27 or local codes.
NOTICE: Where local codes and CE regulatory
requirements apply, appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.
Hard wired models:
Hard wired models must be equipped with a country
certi ed external allpole disconnection switch with
suf cient contact separation.
If a power cord is used for the connection of the product an
oil resistant cord like H05RN or H07RN or equivalent must
be used.
WARNING
Appliances without a cord provided by the
factory must be equipped with a cord of
su icient length to permit the appliance to
be moved for cleaning.
Always use the correct AWG wire size
based on the electrical requirements for
the appliance.
CAUTION
Power source must match voltage identified
on appliance rating tag. The rating tag
provides essential technical information
required for any appliance installation,
maintenance or repairs. Do not remove,
damage or modify the rating tag.
Electrical Specifications
Bekijk gratis de handleiding van Alto-Shaam 1767-SK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alto-Shaam |
| Model | 1767-SK |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 7268 MB |
