Alpine PXE-X120-10DP handleiding
Handleiding
Je bekijkt pagina 5 van 64
in re and so on.
DO NOT INSTALL ON THE STEERING WHEEL OR
GEAR LEVER, ETC., WHICH MAY HINDER THE OPERA
TION OF THE CAR
Otherwise, it will obstruct the front line of sight or ob-
struct moving parts, etc., causing serious accidents.
DO NOT TOUCH THE PRODUCT DURING OPERATION
The temperature of the product rises during operation,
so touching it can cause burns.
NOTICE
This symbol indicates important instructions. Fail-
ure to heed these instructions may result in injury
or major property damage.
WHEN THERE IS A PROBLEM, PLEASE STOP USING IT
IMMEDIATELY
Otherwise, it may cause personal injury or damage to
the product. Please return this product to an autho-
rized Alpine dealer or the nearest Alpine service center
for repair.
ASK PROFESSIONALS FOR WIRING AND INSTALLA
TION
The wiring and installation of this product require
professional skills and experience. For safety reasons,
please contact the dealer where you purchased the
product for installation.
USE DESIGNATED ACCESSORIES AND INSTALL
SECURELY
Make sure to use only designated accessories. The use
of non-designated parts may cause internal damage to
the device, or it may not be securely installed in place.
This can cause parts to loosen and cause danger or
product failure.
The recommended torque for tightening the screws
between the mounting bracket and the product is
37±5 N/cm.
A higher torque may cause damage to the screw hole.
ARRANGE THE WIRES TO AVOID CRIMPING OR BE
ING SQUEEZED BY SHARP METAL EDGES
The arrangement of wires and cables should be far
away from moving parts (such as seat tracks) or sharp
edges or corners. This will avoid crimping and damage
to the wires. If the wiring passes through a metal hole, a
rubber gasket should be used to prevent the wire insu-
lation from being cut by the edge of the metal hole.
DO NOT INSTALL IN HIGH HUMIDITY OR DUSTY
LOCATIONS
Avoid installing the device in a location with high hu-
midity or dust. Moisture or dust invades the device and
can cause product failure.
Precautions
PRODUCT CLEANING
Please use a dry soft cloth to clean the product regular-
ly. If the dirt is dicult to remove, soak a soft cloth with
water only. Any other solvent may dissolve the surface.
TEMPERATURE
Before turning on the device, please make sure that the
temperature in the car is between+60°C and -20°C.
MAINTENANCE
If you encounter a problem, do not repair it yourself.
Please return this product to an authorized Alpine deal-
er or the nearest Alpine service center for repair.
INSTALLATION LOCATION
This device cannot be installed in any of the following
places:
• Near direct sunlight and heat sources
• Places with high humidity and near water sources
• Dusty places
• Locations subject to severe vibration
EN
5-EN
Bekijk gratis de handleiding van Alpine PXE-X120-10DP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alpine |
| Model | PXE-X120-10DP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5160 MB |
