Handleiding
Je bekijkt pagina 4 van 12
4
URS-1 THERMOSTAT REPLACEMENT & BULB LOCATION
To replace the RANCO Thermostat,
(SES part # 210-0023) open the
evaporator coil cover by removing
the thermostat knob (pull out) and
then the mounting screws A & B
shown on the picture below.
Remove the exposed fan plenum by
taking out the 4 bottom mounted
screws located at each corner.
Tilt the fan plenum forward and re-
move the RANCO Thermostat
mounting screws.
Replace the thermostat.
Once the RANCO Thermostat has
been replaced, tuck the excess cap-
illary bulb tubing under the fan wir-
ing and secure in place with zip-ties.
Place the BULB TIP over the left
evaporator fan (approx. 1” exposed
over fan blades) and fasten to the
fan corner mounting hole with a zip-
tie.
Make sure the BULB TIP does not
touch the fan blades, bend tip until it
is approximately 1/4” over the fan
blades.
Close and secure with screws the
fan plenum and coil cover. Replace
the thermostat knob to finish.
A
B
KNOB
FAN
PLENUM
SCREWS
FAN
PLENUM
SCREWS
TUCK EXCESS
CAPILLARY
BULB TUBING
FASTEN BULB
TIP WITH A ZIP
TIE OVER FAN
Bekijk gratis de handleiding van Alfresco URS-1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alfresco |
| Model | URS-1 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 5758 MB |