Alfatron ALF-20X-CAM handleiding
Handleiding
Je bekijkt pagina 15 van 39
ALFATRON ALF-5/10/12/20X/30X-CAM
15
3.1
Video Output
3.1.1
Power-On Initial Configuration
Connecting the power, the camera will have initial configuration, R indicator light will be flashing. When the camera return to the
HOME position (middle position for P/T), and lens finish zoom in/out, the auto-testing is finished. IR led will also stop flashing. If the
preset 0 is set, the camera will rotate to the 0 preset positions after the initial configuration.
3.1.2
Video Output
Connect to the video output cable: the user select the output mode according to the machine model.
Figure 1.4.1 is for your reference (output interface introduction for each product)
1) network output: connect this product and your computer through a network cable, then open the browser, enter the camera IP
address (factory default 192.168.5.163) in the address bar, then to the login page and input a user name and password
(factory default are “admin”), Finally enter the preview page, and the image comes out.
(Note: If you forget your user name, password, IP address, you can manually restore the default by the remote control key
combination * #)
2) 3G-SDI output or DVI (HDMI) output: Connect the monitor with the corresponding video output interface, then the monitor
output image.
3) USB3.0 output: Connect this product with the computer USB3.0 interface (blue), open the Device Manager to see whether
there is an imaging device and whether the Universal Serial Bus controllers recognize the USB3.0 device. After properly identified,
open the software, choose the imaging device, and then it will output the image.
4) USB3.0 compatible with USB2.0 output: Connect this product with a computer USB2.0 interface (black), open the Device
Manager to see whether there is an imaging device and whether the Universal Serial Bus controllers recognize USB3.0 device. After
properly identified, open the software, choose the imaging device, and then it will output the image.
3.2
Remote Controller
3.2.1 Keys Instruction
1. Standby Key
After a 3S long press, the camera will step into standby mode. Long press 3S again, the camera will
self-test again and back to the HOME position. (Note: If power-on mode is turned on and Preset 0 is
set, and there is no operation within 12s, it will automatically point to the specified preset position.
2. Camera Address Selection
Select the camera address which wants to be controlled
3. Number Key
Set or run 0-9 presets
4,*,# Key
Key combination use
5. Focus Control Key
Auto Focus: Enter into autofocus mode.
Manual Focus: The camera focus mode is manual
Switch the camera focus mode to manual focus by pressing [focus +] or [focus -] to adjust.
6. Zoom Control Key
Zoom＋: Lens near
Zoom－: Lens far
7. Set or Clear Preset key:
Set Preset: Set preset key + 0-9 number key:
Clear Preset key: Clear preset key + 0-9 number key
8. Pan/Tilt Control Key
Press Key: Up
Press Key: Down
Press Key: Left
Press Key: Right
“HOME” Key: Return to the middle position or enter into the next level menu
9. BLC Control Key
Back Light ON / OFF: Turn on or off the backlight
Bekijk gratis de handleiding van Alfatron ALF-20X-CAM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alfatron |
| Model | ALF-20X-CAM |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 9506 MB |
