Alfatron ALF-10X-CAM handleiding
Handleiding
Je bekijkt pagina 37 van 39
ALFATRON ALF-5/10/12/20X/30X-CAM
37
Response
Query Zoom Position 0xA0 Address 0x00 0x55 0x00 0x00 0xAF XOR
Query Zoom Position
Response
0xA0
Address
0x00
0x5D
Value High Byte
Value Low Byte
0xAF
XOR
6.
Camera Maintenance and Troubleshooting
6.1 Camera Maintenance
1) If the camera is not used for a long time, please turn off the power adapter switch and AC plug.
2)Use soft cloth or tissue to clean the camera cover.
3)Use a soft cloth to clean the lens; Use neuter cleanser if bad smeared. No use strong or corrosive cleanser or corrosive cleanser
avoiding scuffing.
6.2 Troubleshooting
1) No video output
—— a, Check whether the camera power supply is connected, the voltage is normal, the power indicator is lit.
b, Whether the machine could do self-inspection after restarted.
c, Check whether the bottom of the DIP switch is the normal operating mode
d, Check whether the video output cable or video display is normal
2) No image sometimes
——a, Check whether the video output cable or video display is normal
3) Image dithering when zoom-in or zoom-out
——a, Check whether the camera installation position is solid
b, Whether there is a shaking machine or objects around the camera
4) The remote controller can not work
——a Remote control address is set to 1 (if the machine is set back to the factory defaults, remote control addresses need to be
back to 1 too)
b, Check whether the battery is installed on the remote controller or low.
c, Check the camera working mode is the normal operating mode (see Table 2.2 and Table 2.3)
d, Check the menu whether it is closed, camera control through the remote controller is only available after exiting the menu. If video
output from LAN, the menu will not be displayed, the menu will automatically exist in the 30s later, then it can be controlled by a
remote controller.
5) The serial port can not work.
——a, Check whether the camera serial device protocol, baud rate, address is consistent
b, Check whether the control cable is connected properly
c, Check whether the camera working mode is the normal operating mode (see Table 2.2 and Table 2.3)
6) Web pages can not log in
——a, Check whether the camera is showing normally.
b, Check whether the network cable is connected properly(Ethernet port yellow light flashes to indicate normal network cable
connection)
c, Check whether your computer is added the segment and the segment is consistent with the IP address of the camera
d, Click "Start" and select "Run" and then type “cmd” in the computer; Click "OK" then turn on a DOS command window to enter
Bekijk gratis de handleiding van Alfatron ALF-10X-CAM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Alfatron |
| Model | ALF-10X-CAM |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 9506 MB |
