Alcon AquaComfort Plus handleiding

48 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 15 van 48
15
pressure and return quickly to its original position.
4. Good comfort and stable visual response (with over-refraction)
Characteristics of a Tight (Steep) Lens Fit
A tight or steep lens t would display some or all of the following characteristics:
1. Insufcient or no lens movement during the blink in primary or
upgaze
2. Unsatisfactory Push-Up Test
A tight tting lens will resist movement. If successfully nudged
upward, the lens may remain decentered or return slowly to its
original position.
3. Good centration
4. Good comfort
5. Fluctuating vision between blinks
Characteristics of a Loose (Flat) Lens Fit
A loose or at lens t would display some or all of the following
characteristics:
1. Reduced comfort, usually accompanied by lower lid sensation
2. Poor centration with limbal exposure on exaggerated eye movement
3. Lens edge standoff
4. Excessive lens movement during the blink in primary or upgaze
5. Unsatisfactory Push-Up Test
• A loose tting lens will move easily but may remain decentered
or slip under the upper lid.
6. Vision may be blurred after the blink
An inverted lens will mimic the characteristics of a loose lens. If any of
the above signs occur remove the lens and check to make sure it is not
inverted.
General Fitting Tips
• Whilehelpfulformonitoringcornealstabilityovertime,keratometryis
notareliablepredictorofbasecurve/trelationship.Trialttingofthe
individualeyeisstronglyrecommended.
• Awell-ttinglenswillshowlessmovementthangenerallythought,0.1
to0.5mmisconsideredoptimal.
• Aatbasecurve/cornearelationshipmayactuallyshowlimited
movement.Decentrationandexcessivelidsensationaccompanied
bylimitedmovementoftenindicatesthelensistooatforthegiven
eye.
Ifthecriteriaforawell-ttedlenscannotbeachieved,donotdispense.
C. Initial Lens Orientation Evaluation
No Rotation
When the scribe lines orient horizontally, the cylinder axis of the lens that is
dispensed or ordered should be the same as the spectacle refractive axis -
not the trial lens axis.
Contact lens cylinder axis = Spectacle refractive axis

Bekijk gratis de handleiding van Alcon AquaComfort Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAlcon
ModelAquaComfort Plus
CategorieNiet gecategoriseerd
TaalNederlands
Grootte4631 MB

Caratteristiche Prodotto

MateriaalNelfilcon A
Aantal per verpakking90 stuk(s)
Type productDagelijks
Ultraviolet ( UV) beschermingNee
Lens diameter14 mm