Handleiding
Je bekijkt pagina 24 van 339
21
1.
To bend a pi
pe, give the roundness as large as possible not to crush the pipe ,
and the bending radius should be 30 to 40
mm or longer.
Connecting the pipe of gas side
rst makes working easier.
The connection pipe is specialized for R32.
Half union
Flare nut
Torque wrench
CAUTION
Be careful that matters, such as wastes of sand
s,water,
, etc. shall not enter the pipe.
The standard pipe length is Cm. If it is over D m, the function of the unit will be affected. If the pipe
has
to be lengthened, the refrigerant should be charged,
according to E g/m. But the charge of refrigerant
must
be conducted by profes
sional air conditioner engineer. Before adding additional refrigerant,
perform
air
purging from the refrigerant pipes and indoor unit using a vacuum pump,then
Spanner
Forced fastening without careful centering may
damage the threads and cause a leakage of gas.
Pipe Diameter( ) Fastening torque
Liquid side6.35mm(1/4")
Liquid/Gas side9.52mm(3/8")
Gas side 12.7mm(1/2")
Gas side 15.88mm(5/8")
Connection of pipes
charge
additional refrigerant.
2.
Outdoor unit
B
Indoor unit
B
A
A
Indoor unit
Outdoor unit
Max.Elevation:
Amax
In case the elevation A is more
than 5m, oil trap shoud be
installed every 5~7
Max. Length:
Bmax
Mi n. Length:
B min
In case the pipe length B is
more thanDm, the refrigerant
should be charged, according
to E g/m.
Outdoor unit
B
Oil trap
Indoor unit
A
The values are shown in table 5
18~20N.m
30~35N.m
35~45N.m
45~55N.m
The values of The piping size are shown
in table 4
Bekijk gratis de handleiding van Aiwa FUJINAIR 24 ACD-24100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Aiwa |
| Model | FUJINAIR 24 ACD-24100 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 51004 MB |
