Aiphone GT-102HB handleiding
Handleiding
Je bekijkt pagina 25 van 52
- 25 -
1 Mount the mounting bracket on the wall.
* When using a gang box, a single gang box is recommended.
2 Connect wires to the
terminal block.
* If it is diffi cult to insert the
wire, insert it while pressing
the release button.
• To remove the terminal block, slide the terminal block and pull it out.
• Strip away the jacket of the wire and insert all wires into the slots in
an orderly fashion. Failure to do so could result in pinching that may
damage the wiring.
• For surface wiring, cut out the cable inlet.
NOTE: Be sure to route the wires inside the cable guides.
Otherwise, the wires could be damaged when attaching
the station to the mounting bracket.
3 Mount the station to the mounting bracket.
SW1 A B
IN OUT
R1 R2 R1 R2 C
0.65 10 9
CE K KE
Do not remove the wires (For end users)
SW1
AB
IN OU
T
R1
R2
R1
R2 C
0.65 10
9
CE K
KE
Do not remove the wires (For end users)
SW1
A
B
IN OUT
R1 R2 R1 R2
C
CE
K
KE
Do not remove the wires ! (For end users)
0.65~10 9mm
Terminal block
Cable inlet
Cable guide
Mounting screw
(included)
Mounting bracket
Mounting screw
83.5 mm (3-5/16")
GT-1A
1
2
3
Be careful not to damage the circuit board when connecting wires and
mounting the station. Failure to do so could damage the station.
NOTE : The surface wiring method cannot be used.
1 Remove the screw, and then remove the case from the chassis.
2 Route the wires through the wire inlet of the chassis, and then connect
the wires.
Turn off the GT-BC control unit before connecting wires. Failure to
do so could damage the station.
3 Attach the chassis on the wall.
* Be careful not to pinch the wires between the chassis and the wall.
* When using a gang box, a single gang box is recommended.
4 Attach the case to the chassis and tighten the screw.
5 Plug in the handset to the jack.
* The image of the terminals may differ from the actual product.
Chassis
Inlet
Case
Handset
Screw
83.5 mm (3-5/16")
83.5 mm
(3-5/16")
15 mm
(9/16")
10 mm
(3/8")
GT-1D
Release button
Release button
ø30mm (1-3/16”)
ø30mm (1-3/16”)
ø30mm
(1-3/16”)
Bekijk gratis de handleiding van Aiphone GT-102HB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Aiphone |
| Model | GT-102HB |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9766 MB |
Caratteristiche Prodotto
| Kleur van het product | Bruin |
| Aantal per verpakking | 1 stuk(s) |
| Merkcompatibiliteit | Aiphone |
| Type product | Opbouwdoos |
