AFX HOTBEAM-3R-PACK handleiding
Handleiding
Je bekijkt pagina 4 van 40
EN 4
© Copyright LOTRONIC 2022
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external exible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualied person in order to avoid a hazard.
• The lenses, housing or ultraviolet lter must be replaced if they are visibly damaged.
• The lamp shall be changed if it has become damaged or thermally deformed
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
INSTALLATION
• This xture may be mounted in any position, provided there is adequate room for ventilation
• It is important never to obstruct the fan or vents pathway.
• When selecting installation location, take into consideration lamp replacement access and rou-
tine maintenance.
• Safety cables must always be used.
• Never mount in places where the xture will be exposed to rain, high humidity, extreme temper-
ature changes or restricted ventilation.
POWER SUPPLY AND SIGNAL CABLE CONNECTION
1. MAINS POWER CONNECTION
CAUTION: When installing the device, make sure there is no highly inammable material within a
distance of min.5m!
2. CONNECTION OF SIGNAL CABLE
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of
the slave light. Connect the DIGITAL OUT socket of the master and the IN socket of the slave light,
then, connect the OUT socket to the IN socket of the next light. Ordinal to connect all the lights as
below:
IN OUT OUTIN OUTIN
DMX IN
Resistor
3
rd
Light
2
nd
Light
1
st
Light
120Ω 1W
2 3
The connection between the output of master and input of product, it’s available to use the 3 pins
XLR cable which provided by the manufacturer. Signal cable from the DMX output of the controller
to the input of the rst master light, and connect to the DMX input of second slave light from the
DMX output of the rst master light, analogously, till connected all
the slave lights, and insert the last connector to the output of the
nal light. (Notice: the diameter of core of every cable should be
0.5mm at least, double core shelter cable should be used).The sig-
nal connecting must use the attached 3 pins XLR cable. Notice, all
the internal lead wire of the 3 pins XLR cable should not touch to
each other or connect to the connector.
DMX signal terminator is recommended on the last unit of the
chain. DMX terminator is a XLR connector with a 120Ω resistor be-
tween the pin 2 and pin 3 of the XLR connector
Bekijk gratis de handleiding van AFX HOTBEAM-3R-PACK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AFX |
| Model | HOTBEAM-3R-PACK |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 7949 MB |
