AFX CLUB-UV450-IP handleiding
Handleiding
Je bekijkt pagina 4 van 24
EN 4
© Copyright LOTRONIC 2024
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external exible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualied person in order to avoid a hazard.
• The lenses, housing or ultraviolet lter must be replaced if they are visibly damaged.
• The light source is not replaceable. It it is faulty, the product must be discarded.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket.
Always ensure that the unit is rmly xed to avoid vibration and
slipping while operating. Always ensure that the structure to which
you are attaching the unit is secure and is able to support a weight
of 10 times of the unit’s weight.
The installation must always be secured with a secondary safety
attachment, e.g. an appropriate safety rope.
Never stand directly below the device when mounting, removing or
servicing the xture.
DMX CONNECTION
Connect an XLR cable to the male 3-pin XLR output of your control-
ler and the other side to the female 3-pin XLR input of the light.You
can chain multiple lights together through serial linking
The cable needed should be two core, screened cable with XLR in-
put and output connectors.
DMX OUT
POWER IN
POWER OUT
MENU
DMX IN
UP DOWNE NTER
EVACUATION VALVE
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
Termination reduces signal errors. To avoid signal transmission problems and interference, it is
always advisable to connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the xture’s chassis ground. Grounding the com-
mon can cause a ground loop, and your xture may perform erratically. Test cables with an ohm
meter to check correct polarity and to make sure the pins are not grounded or shorted to the shield
or each other.
Bekijk gratis de handleiding van AFX CLUB-UV450-IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AFX |
| Model | CLUB-UV450-IP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3906 MB |
