AENO AP3 handleiding
Handleiding
Je bekijkt pagina 11 van 112

aeno.com/documents 11
• FILTER button that is blinking every time the filter shall be replaced (an
audible signal will also be emitted. You may stop it by pressing this button
again);
• UV-C button used to turn on the UV lamp intended for air disinfection.
Maintenance
The HEPA filter shall be cleaned on a regular basis, but never rinsed up with
water or used after the end of service life. Please dry the HEPA filter regularly in
the sun. Do not remove dust from the HEPA filter with a vacuum cleaner or a
water jet.
The HEPA filter shall be replaced every 2,200 hours of operation (i.e. every 3-6
months). To remove dust from the HEPA filter, you shall remove it from the
purifier casing. Use a soft cloth with a neutral (non-aggresive) detergent to
remove dust or large pieces of dirt from the surface of the HEPA filter. The HEPA
filter shall be installed back in the purifier casing only after it gets dried. If the
device is not planned to be used for a long time, please store it covered with a
dustproof bag in a dry, cool and well-ventilated area. It is also recommended to
power on the device from time to time for at least a few minutes in order to keep
it in a good working condition.
ATTENTION! Do not allow water to enter the purifier.
Troubleshooting
1. The purifier does not turn on. Make sure that the purifier is plugged into the
mains socket, and that there is no power supply failure, as well as that the
circuit breaker is on, and that the fuses are intact, and that the filter change
LED is blinking red.
2. The device makes a loud noise. Make sure that nothing is stuck in the fan,
and that the purifier is not tilted. If the noise is still too loud, try to reduce
the fan speed using the Speed Mid or the Sleep button. Also, use Sleep
Mode to operate the purifier at night.
3. Unpleasant odor coming from the purifier. If the device emits a plastic smell
during the first few hours of operation, this is deemed to be normal. However,
Bekijk gratis de handleiding van AENO AP3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AENO |
| Model | AP3 |
| Categorie | Luchtreiniger |
| Taal | Nederlands |
| Grootte | 9087 MB |
Caratteristiche Prodotto
| Soort bediening | Touch |
| Kleur van het product | Wit |
| Ingebouwd display | Ja |
| Gewicht | 1900 g |
| Breedte | 205 mm |