Handleiding
Je bekijkt pagina 24 van 72
the programme has to finish within 12
hours.)
3. Touch the Avvio/Pausa button. The drum
starts rotating to perform the ProSense
estimation, if foreseen in the selected
programme.
4. The appliance starts the countdown to the
end of the programme and the
programme will start at the right moment
for ending.
11.11 The ProSense load detection
The ProSense technology detects the
laundry load size defining the programme
duration. Works with most of the
programmes.
After setting a drying programme the
icon lights up if the laundry load
detection is applicable.
Touching the Avvio/Pausa button, the
ProSense starts the laundry load detection:
1. The appliance detects the load in the first
minute: the indicator flashes, the bars
under the icon move back and forth
and the drum rotates shortly.
2. When the drum stops rotating, the display
shows the new programme duration
adjusted according to the detected load.
The number of bars, from 1 to 4,
represents the estimated load amount. 4
bars represent the maximum load amount
for the selected programme.
In case of drum overload, the maximum
declared load indicator comes on again
with the indicator blinking. In
this case, during these 30 seconds, it is
possible to open the door and remove
the exceeding garments. Once removed,
touch the Avvio/Pausa button to start the
programme again. If the laundry amount
will not be reduced, the programme starts
anyway. In this case, it will be not
possible to guarantee the best results.
11.12 Programme change
To change a programme:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn on
the appliance.
3. Set a new programme.
11.13 Programme end
Clean the filter and drain the water
container after each drying cycle. (See
chapter CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Fine option is
activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the
anti-crease phase starts (not active with
all programmes). Flashing symbol
signals the execution of the anti-crease
phase. Laundry can be removed during
this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds to
turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
See chapter
Adjustment of the target final
moisture
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Leave the door slightly opened after
every cycle to avoid moisture.
24 ENGLISH
Bekijk gratis de handleiding van AEG TR9HH8BY, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | TR9HH8BY |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 6531 MB |
