Handleiding
Je bekijkt pagina 30 van 36
In case of major problems, the acoustic signals operate, the display shows an error
code and the Start/Pause button may flash continuously:
Table title
Error code Possible cause Remedy
E50
Appliance motor overloaded.
Too much laundry or entrapped in the drum.
The programme was not completed. Re‐
move the laundry from the drum, set the
programme and restart the cycle.
E90 or E91
Internal fail. No communication between
electronic elements of the appliance.
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
EH0
The mains supply is unstable. When the appliance is showing EH0, please
wait until main supply is stable than press
start. If the appliance paused the cycle with‐
out any indication then press the cycle start.
If the warning will occur again check the
power cord / socket integrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
14.2 Troubleshooting
Table title
Problem Possible cause Remedy
The tumble dryer
does not operate.
The tumble dryer is not connected to the
mains supply.
Connect it to the mains socket. Check the
fuse in the fuse box (domestic installation).
The door is open. Close the door.
The On/Off button was not pushed. Push the On/Off button.
The Start/Pause button was not touched. Touch the Start/Pause button.
The appliance is in standby mode. Push the On/Off button.
Unsatisfactory drying
result.
Incorrect program selection.
Select a suitable program.
1)
The filter is clogged.
Clean the filter.
2)
Dryness Level option was set to
Iron
Dry
.
3)
Change Dryness Level option to a higher
level.
The load was too large. Do not exceed the maximum load size.
The airflow slots are clogged. Clean the airflow slots at the bottom of the
appliance.
There is some dirt on the humidity sensor in
the drum.
Clean the front surface of the drum.
The dryness level was not set to the desired
level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
30 ENGLISH
Bekijk gratis de handleiding van AEG TR959V6BC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | TR959V6BC |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 3263 MB |
