Handleiding
Je bekijkt pagina 24 van 60
Error code Possible cause Remedy
E90 or E91
Internal fail. No communication between
electronic elements of the appliance.
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
EH0
The mains supply is unstable. When the appliance is showing EH0, please
wait until main supply is stable than press
start. If the appliance paused the cycle with‐
out any indication then press the cycle start.
If the warning will occur again check the
power cord / socket integrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
13.2 Troubleshooting
Problem Possible cause Remedy
The tumble dryer
does not operate.
The tumble dryer is not connected to the
mains supply.
Connect it to the mains socket. Check the
fuse in the fuse box (domestic installation).
The door is open. Close the door.
The On/Off button was not pushed. Push the On/Off button.
The Avvio/Pausa button was not touched. Touch the Avvio/Pausa button.
The appliance is in standby mode. Push the On/Off button.
Unsatisfactory drying
result.
Incorrect program selection.
Select a suitable program.
1)
The filter is clogged.
Clean the filter.
2)
Livello Asciugatura option was set to
pronto stiro
.
3)
Change Livello Asciugatura option to a
higher level.
The load was too large. Do not exceed the maximum load size.
The airflow slots are clogged. Clean the airflow slots at the bottom of the
appliance.
There is some dirt on the humidity sensor in
the drum.
Clean the front surface of the drum.
The dryness level was not set to the desired
level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
The loading door
does not close
The filter is not locked into position. Put the filter in the correct position.
Laundry is trapped between the door and
the seal.
Remove trapped items and close the door.
24 ENGLISH
Bekijk gratis de handleiding van AEG TR7G83W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | TR7G83W |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 5023 MB |
