Handleiding
Je bekijkt pagina 33 van 76
Problem Possible cause Solution
The Extra Cool function is switched
on.
Refer to "Extra Cool function" sec‐
tion.
The compressor does not start im‐
mediately after pressing the "Extra
Freeze" or "Extra Cool", or after
changing the temperature.
The compressor starts after a period
of time.
This is normal, no error has occur‐
red.
Door is misaligned or interferes with
ventilation grill.
The appliance is not levelled. Refer to installation instructions.
Door does not open easily. You attempted to re-open the door
immediately after closing.
Wait a few seconds between closing
and re-opening of the door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the Authorized Service
Centre.
There is too much frost and ice. The door is not closed correctly. Refer to "Closing the door" section.
The gasket is deformed or dirty. Refer to "Closing the door" section.
Food is not wrapped properly. Wrap the food properly.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Appliance is fully loaded and is set
to the lowest temperature.
Set a higher temperature. Refer to
"Control panel" chapter.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
Set a higher temperature. Refer to
"Control panel" chapter.
Water flows on the rear plate of the
refrigerator.
During the automatic defrosting
process, frost melts on the rear
plate.
This is correct.
There is too much condensed water
inside the fridge.
Door was opened too frequently. Open the door only when necessa‐
ry.
Door was not closed completely. Make sure the door is closed com‐
pletely.
Stored food was not wrapped. Wrap food in suitable packaging be‐
fore storing it in the appliance.
This is normal that during summer
and autumn more condensation can
form due to the increased air and
food humidity. Fridge does not pro‐
duce any moisture. After this period,
the humidity in the fridge decreases
itself.
In summer and autumn, set the
warmer temperature in the refrigera‐
tor (approx. 6-7°C).
There are water drops on the glass
shelves.
There is too much moisture inside
the fridge.
Wipe the glass shelves with a cloth
to remove water drops.
Water flows on the floor. The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
Attach the melting water outlet to
the evaporative tray.
ENGLISH 33
Bekijk gratis de handleiding van AEG TC7MS181CF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | TC7MS181CF |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 6655 MB |
