Handleiding
Je bekijkt pagina 14 van 20
11.3 Removing the shelf supports
Remove the shelf supports to clean the
appliance.
1. Turn off the appliance and wait until it is
cold.
2. Pull the front of the shelf support away
from the side wall.
3. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
4. Install the shelf supports in the opposite
sequence.
If the telescopic runners are supplied, its
retaining pins must point to the front.
11.4 Aqua Clean
This cleaning procedure uses humidity to
remove remaining fat and food particles from
the appliance.
1. Pour water into the cavity embossment:
300 ml.
2. Set the function
.
3. Set the temperature to 90 °C.
4. Let the appliance work for 30 min.
5. Turn off the appliance.
6. Wait until the appliance is cold. Dry the
cavity with a soft cloth.
11.5 Removing and installing door
You can remove the oven door and the
internal glass panels to clean them. Read the
whole "Removing and installing door"
instruction before you remove the glass
panels.
CAUTION!
Do not use the appliance without the
glass panels.
1. Open the door fully and hold both hinges.
2.
Lift and pull the latches until they click.
3. Close the oven door halfway to the first
opening position. Then lift and pull to
remove the door from its seat.
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim
on the top edge of
the door at the two sides and push
inwards to release the clip seal.
1
2
A
6. Pull the door trim to the front to remove it.
7. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide. Make sure the glass slides out
of the supports completely.
14 ENGLISH
Bekijk gratis de handleiding van AEG OA5AE23AB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | OA5AE23AB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 1609 MB |
