Handleiding
Je bekijkt pagina 13 van 60
Problem Possible cause Solution
Acoustic or visual alarm is on. The cabinet has been recently
switched on.
Refer to "High temperature alarm"
or "Door open alarm".
The temperature in the appliance is
too high.
Refer to "High temperature alarm"
or "Door open alarm".
The door is left open. Close the door.
The compressor operates continual‐
ly.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Too much food is put in at the same
time.
Wait a few hours and then check the
temperature again.
The room temperature is too high. Refer to "Installation" chapter.
Food placed in the appliance is too
warm.
Allow food to cool to room tempera‐
ture before storing.
The door is not closed correctly. Refer to "Closing the door" section.
The Extra Freeze function is switch‐
ed on.
Refer to "Extra Freeze function"
section.
The compressor does not start im‐
mediately after pressing the "Extra
Freeze", or after changing the tem‐
perature.
The compressor starts after a period
of time.
This is normal, no error has occur‐
red.
Door is misaligned or interferes with
ventilation grill.
The appliance is not levelled. Refer to installation instructions.
Door does not open easily. You attempted to re-open the door
immediately after closing.
Wait a few seconds between closing
and re-opening of the door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the Authorized Service
Centre.
There is too much frost and ice. The door is not closed correctly. Refer to "Closing the door" section.
The gasket is deformed or dirty. Refer to "Closing the door" section.
Food is not wrapped properly. Wrap the food properly.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Appliance is fully loaded and is set
to the lowest temperature.
Set a higher temperature. Refer to
"Control panel" chapter.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
Set a higher temperature. Refer to
"Control panel" chapter.
Water flows on the rear plate of the
refrigerator.
During the automatic defrosting
process, frost melts on the rear
plate.
This is correct.
There is too much condensed water
inside the fridge.
Door was opened too frequently. Open the door only when necessa‐
ry.
ENGLISH 13
Bekijk gratis de handleiding van AEG NSC6M18FDS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | NSC6M18FDS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 5080 MB |
