Handleiding
Je bekijkt pagina 23 van 32
8. Pull the door trim to the front to remove it.
9. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
10. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
11.12 Replacing the lamp
WARNING!
Risk of electric shock.
WARNING!
Risk of injury when removing the glass
cover.
WARNING!
Risk of burns, the glass cover may be
hot. Use protective glove when touching
the lamp.
1. Turn off the appliance. Wait until the
appliance is cold.
2. Disconnect the appliance from the mains.
3. Use a Torx 20 screwdriver to remove the
glass cover.
4. Remove and clean the metal frame and
the seal.
5. Replace the lamp with a suitable 300°C
heat-resistant lamp.
6. Install the metal frame and the seal.
Tighten the screws.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem description Cause and remedy
You cannot activate or operate the
appliance.
The appliance is not connected to an electrical supply or it is connected in‐
correctly.
The appliance does not heat up. The clock is not set.
To set the clock refer to "Clock functions" chapter.
The door is not closed correctly.
The fuse is blown.
Make sure the fuse is the cause of the problem. If the problem recurs, con‐
tact a qualified electrician.
Child Lock is activated.
ENGLISH 23
Bekijk gratis de handleiding van AEG NKB9A82KB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | NKB9A82KB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 2797 MB |
