Handleiding
Je bekijkt pagina 24 van 32
12.1 What to do if...
Problem description Cause and remedy
You cannot activate or operate the
appliance.
The appliance is not connected to an electrical supply or it is connected in‐
correctly.
The appliance does not heat up. The clock is not set.
To set the clock refer to Clock functions.
The door is not closed correctly.
The fuse is blown.
Make sure the fuse is the cause of the problem. If the problem recurs, con‐
tact a qualified electrician.
Child Lock is activated.
The lamp is turned off. The lamp is burnt out. Replace the lamp.
For details refer to Care and cleaning.
The appliance does not retain the
water tank after you insert it.
You did not fully press the water tank body.
Fully insert the water tank into the appliance.
Water comes out of the water
tank.
You did not assemble the lid of the water tank correctly.
The water tank is difficult to clean. Mare sure that the lid is removed before you start cleaning.
There is no water inside the tray
after descaling.
The water tank was not filled in to the maximum level.
Check if a descaling agent / water is present in the water tank body.
There is dirty water on the bottom
of the cavity after descaling.
The tray is on a wrong shelf position.
Remove the remaining water and the descaling agent from the bottom of the
appliance. Next time put the tray on the first shelf position.
There is too much water on the
bottom of the cavity after cleaning.
You put too much detergent in the appliance before you started cleaning.
Next time evenly spread the thin layer of a detergent on the cavity walls.
Cleaning performance is not satis‐
factory.
You started cleaning when the appliance was too hot.
Wait for the appliance to cool down. Repeat cleaning.
You did not remove all the accessories from the appliance before cleaning.
Remove all the accessories and repeat cleaning.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
Trouble with wireless network sig‐
nal.
Check if your mobile device is connected to the wireless network. Check
your wireless network and router.
Restart the router.
New router installed or router con‐
figuration changed.
To configure appliance and mobile device again, refer to Before first use,
Wireless connection.
The wireless network signal is
weak.
Move router as close to the appliance as possible.
The wireless signal is disrupted by
microwave oven placed near the
appliance.
Turn off the microwave oven.
Avoid using microwave oven and the Remote operation of the appliance at
the same time. Microwaves disrupt WiFi signal.
12.2 Error codes
When the software error occurs, the display shows error message. You will find the list of
problems in the table below.
24 ENGLISH
Bekijk gratis de handleiding van AEG NBP9S83PAB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | NBP9S83PAB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 2839 MB |
