AEG LR7FD104B handleiding
Handleiding
Je bekijkt pagina 11 van 88
2. Position it toward left or right depending
on the position of the tap. Make sure that
the inlet hose is not in vertical position.
3. If necessary, loose the ring nut to set it in
the correct position
4. Connect the water inlet hose to the cold
water tap with 3/4" thread.
Some model can contain inlet hose with
water stop device. It prevents any leaks in the
hose because of its natural ageing. The
sector in the window shows this fault A. If this
occurs, close the water tap and contact the
authorized service center for information to
replace the hose.
3/4”
3/4”
A
A
A
WARNING!
The inlet water shall not exceed 25 °C.
CAUTION!
Make sure that there are no leaks from
the couplings.
Do not use an extension hose if the inlet
hose is too short. Contact the service
centre for information on inlet hose
replacement.
5.5 Water drainage
The drain hose should be positioned at a
height of not less than 60 cm and not more
than 100 cm from the floor.
You can extend the drain hose to
maximum 400 cm. Contact the
authorized service centre to buy the other
drain hose and the extension.
It is possible to connect the drain hose in different ways:
min.600 mm
max.1000 mm
(
*
)
(
*
)
(
*
)
(*) Subject to change without notice.
ENGLISH 11
Bekijk gratis de handleiding van AEG LR7FD104B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | LR7FD104B |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 8239 MB |
