AEG ABE4502C handleiding
Handleiding
Je bekijkt pagina 4 van 68
www.aeg.com4
4 www.aeg.com
● If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
● If the appliance is equipped with an Ice maker or a water dispenser,
fill them with potable water only.
● If the appliance requires a water connection, connect it to potable
water supply only.
● The inlet water pressure (minimum and maximum)must be between
1 bar (0,1 MPa) and 10 bar (1 MPa)
2. AFETY INTRUTION
2.1 Installation
WARNING!
Only a qualified person
must install this appliance.
● Remove all the packaging.
● Do not install or use a damaged
appliance.
● Obey the installation instruction
supplied with the appliance.
● Always be careful when you move
the appliance because it is heavy.
Always wear safety gloves.
● Make sure the air can circulate
around the appliance.
● Wait at least 4 hours before connecting
the appliance to the power supply.
This is to allow the oil to flow back in
the compressor.
● Do not install the appliance close to
radiators or cookers, oven or hobs.
● The rear of the appliance must stand
against the wall.
● Do not install the appliance where
there is direct sunlight.
● Do not install this appliance in areas
that are too humid or too colds, such
as the construction appendices,
garages or wine cellars.
● When you move the appliance, lift it by
the front edge to avoid scratching the
floor.
2.1 Electrical connection
WARNING!
Risk of fire and electrical
shock
● The appliance must be earthed.
● All electrical connections should
be made by a qualified electrician.
● Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
● Always use a correctly installed
shockproof socket.
● Do not use multi-plug adapters and
extension cables.
● Make sure not to cause damage to
the electrical components (e.g. mains
plug, mains cable, compressor).
Contact the Service or an electrician
to change the electrical components.
● The mains cable must stay below the
level of the mains plug.
● Connect the mains plug to the
mains socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
● Do not pull the mains cable to
disconnect the appliance. Always
pull the mains plug.
Bekijk gratis de handleiding van AEG ABE4502C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AEG |
| Model | ABE4502C |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6960 MB |
