Adventys GLN 2500 K handleiding
Handleiding
Je bekijkt pagina 35 van 39
35
Manual service
EN
FREE STANDING INDUCTION
GLN MANETTE 2500 / 3000 / 3500
TECHNICAL
FEATURES
SECURITY AND PROBLEMS:
If you read on the keyboard a message ER.XX (with XX 01 to 19), see the follo-
wing table.
Display Key-
board error
Potenal causes Intervenon
ER.01 In vitro sensor in short circuit slave home AFTER SALES
ER.02 In vitro sensor cut o or absent slave home AFTER SALES
ER.03 Sensor in vitro short-circuit master focus AFTER SALES
ER.04 In vitro sensor cut o or absent master replace AFTER SALES
ER.05 IGBT sensor shorted AFTER SALES
ER.05 Sensor temperature generator card cut or missing AFTER SALES
ER.06 IGBT temperature sensor switched o or missing AFTER SALES
ER.06 Sensor temperature generator in short circuit AFTER SALES
ER.07 Temperature on IGBT too high Press on / o key to acknowledge fault, or dis-
ER.08 The temperature of the in vitro sensor does not vary
Press the on / o key to acknowledge the fault
or disconnect / reconnect product. If error code
sll present: Call Aer sales service.
ER.13 One or more fans missing or defecve
ER.14 One or more fans missing or defecve
ER.15 Measuring fault of the inducve current
ER.16 Failure to measure the phase of the inducve current
ER.18 Internal 13.8-volt generator voltage fault
ER.29 Analogue safety fault
ER.31 Slave generator communicaon fault
ER.09 Mains voltage below 85 Vac
ER.20 Mains frequency below 285 Hz
ER.10 Line voltage greater than 285 Vac
ER.19 Mains frequency greater than 70 Hz
Bekijk gratis de handleiding van Adventys GLN 2500 K, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adventys |
| Model | GLN 2500 K |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6594 MB |
