Advantech UBC-220 handleiding
Handleiding
Je bekijkt pagina 14 van 62
UBC-220 User Manual 6
2.1 Jumpers
2.1.1 Jumper Description
Cards can configured by setting jumpers. A jumper is a metal bridge used to close an
electric circuit. It consists of two metal pins and a small metal clip (often protected by
a plastic cover) that slides over the pins to connect them. To close a jumper, you con-
nect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1,2 and 3. In this case you would connect either
pins 1 and 2 or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
2.1.2 Jumper List
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers.
12 12
Table 2.1: Jumper List
SW2 Boot Device
LVDS_VDD_SLT LVDS Power
LVDS_BKLT_SLT Backlight Power
Bekijk gratis de handleiding van Advantech UBC-220, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | UBC-220 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9194 MB |
