Advantech RSB-4810 handleiding
Handleiding
Je bekijkt pagina 15 van 74
7 RSB-4810 User Manual
Chapter 2 Hardware Installation
2.3 Jumpers
2.3.1 Jumper Description
Cards can be configured by setting jumpers. A jumper is a metal bridge used to close
an electric circuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To close a jumper, con-
nect the pins with the clip. To open a jumper, remove the clip. Sometimes a jumper
will have three pins labeled 1, 2, and 3. In such cases, connect either pins 1 and 2 or
pins 2 and 3.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before making any changes. Generally, only a
standard cable is required to make most connections.
2.3.2 Jumper List
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers.
Table 2.1: Jumper List
J1 MASKROM mode select
J2 CAN impedance matching
J3 CAN impedance matching
J4 OTG Mode selection, default USB3.0 host
SW1 AT & ATX Mode Switch, default AT mode
BLP1 LVDS BKL PWR 3.3V&5V level select, default 5V
BLP2 LVDS BKL PWR 12V select
VDD1 EDP VDD 3.3V & 5V level select, default 3.3V
VDD2 LVDS VDD 3.3V & 5V level select, default 3.3V
J5 COM5,COM6 power 12/5V level select, default 5V
Bekijk gratis de handleiding van Advantech RSB-4810, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | RSB-4810 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9257 MB |
