Advantech RSB-3730 handleiding
Handleiding
Je bekijkt pagina 14 van 60
RSB-3730 User Manual 8
2.3 Jumpers
2.3.1 Jumper Description
Cards can be configured by setting jumpers. A jumper is a metal bridge used to close
an electric circuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To close a jumper, you
connect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1,2 and 3. In this case you would connect either
pins 1 and 2, or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
2.3.2 Jumper List
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers.
Table 2.1: Jumper List
VDD VDD 3.3V & 5V LVDS VDD & Backlight power level select
BLP1 LVDS Backlight power 12V select
SW1 AT & ATX Mode select and boot mode select
BTN Power Button
Bekijk gratis de handleiding van Advantech RSB-3730, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | RSB-3730 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6899 MB |
