Advantech PPC-312SW handleiding
Handleiding
Je bekijkt pagina 21 van 66
PPC-312S(W) RPL User Manual
11
Chapter
2
System
Setup
2.2.3 Installation of SSD / iDoor Module
2.2.3.1 Preparation
Carefully follow each step outlined below to ensure proper setup before starting
the installation of an SSD or iDoor module.
NOTE!
An add-on box for SSD & iDoor expansion (98R1P312S10) is re-
quired for SSD / iDoor module installation.
1. Remove the rear cover – Refer to Section 2.2.1 for detailed instructions.
2. Remove the blank cover from the rear panel to reveal the hole for the I/O
cable.
3. Connect the I/O cable to the appropriate connector on the motherboard,
then route it through the hole.
Figure 2.4 Blank Cover Removal
4. Reattach the rear cover to the chassis, securing it with four screws. Take
care not to damage the I/O cable during this process.
Figure 2.5 Re-installing Rear Cover
Bekijk gratis de handleiding van Advantech PPC-312SW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PPC-312SW |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8533 MB |
