Advantech POC-615 handleiding
Handleiding
Je bekijkt pagina 29 van 68
13 POC-615-12 Series User Manual
Chapter 2 System Setup
2. Prepare the grounding cable and the other terminal link to hospital ground/earth
system.
Figure 2.6 Grounding cable with connector
3. Grounding cable plug with POC-615-12 SERIES Equipotential terminal (see
Figure 2.6)
2.3 Running the BIOS Setup Program
Your POC-615-12 was probably set up and configured by your dealer prior to deliv-
ery. You may still find it necessary to use the BIOS (Basic Input-Output System)
setup program to change system configuration information, such as the current date
and time or your type of hard drive. The setup program is stored in read-only mem-
ory. It can be accessed either when you turn on or reset the panel PC by pressing the
"F2” or “Del" key on your keyboard immediately after powering on the computer.
The settings you specify with the setup program are recorded in a special area of
memory called CMOS RAM. This memory is backed up by a battery so that it will not
be erased when you turn off or reset the system. Whenever you turn on the power,
the system reads the settings stored in CMOS RAM and compares them to the
equipment check conducted during the power on self-test (POST). If an error occurs,
an error message will be displayed on screen, and you will be prompted to run the
setup program.
2.4 Installing System Software
Recent releases of operating systems from major vendors include setup programs
which load automatically and guide you through hard disk preparation and operating
system installation. The guidelines below will help you determine the steps necessary
to install your operating system on the panel PC hard drive.
If required, insert your operating system's installation or setup diskette into the exter-
nal diskette drive until the release button pops out.
The BIOS supports system boots up directly from the Flash disk. You may also insert
your system installation Flash disk into USB port.
Power on or reset the system by pressing the “Del” key to boot into the BIOS menu
and adjust the boot device sequence.
You can also press the F12 key when booting. A bootable device popup menu will
appear. You can select the bootable device you prefer. The point-of-care terminal will
automatically load the operating system from the flash disk.
Note! Some distributors and system integrators may have already pre-
installed system software prior to shipment of your panel PC.
Bekijk gratis de handleiding van Advantech POC-615, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | POC-615 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8058 MB |
