Advantech PCIE-1824 handleiding
Handleiding
Je bekijkt pagina 21 van 30
15 PCIE-1824 User Manual
Chapter 3 Signal Connections
3.2.1 Board ID (SW1)
The PCIE-1824 has a built-in DIP switch (SW1), which is used to define each card’s
board ID. When there are multiple cards on the same chassis, this board ID switch is
used to set each card’s device number.
After setting each PCIE-1824, you can identify each card in system with different
device numbers. The default value of board ID is 0 and if you need to adjust it to
other value, please set the SW1 by referring to Table 3.1.
3.2.2 Power On Configuration(JP2)
The default configuration after power on and hardware reset is to set all the analog
input and analog output channels to open status (output voltage equals zero) so that
external devices will not be damaged when the system starts or resets. When the
system is hot reset, then the status of isolated digital output channels are selected by
jumper JP2. Table 3.2 shows the possible configurations of jumper JP2.
Table 3.1: Board ID configuration
SW1
1 2 3 4 Board ID
ON ON ON ON 0
ON ON ON OFF 1
ON ON OFF ON 2
ON ON OFF OFF 3
ON OFF ON ON 4
ON OFF ON OFF 5
ON OFF OFF ON 6
ON OFF OFF OFF 7
OFF ON ON ON 8
OFF ON ON OFF 9
OFF ON OFF ON 10
OFF ON OFF OFF 11
OFF OFF ON ON 12
OFF OFF ON OFF 13
OFF OFF OFF ON 14
OFF OFF OFF OFF 15
Table 3.2: Keep last status jumper configuration.
JP2 Description
(1:2) Keep last status after hot reset
(2:3) Not keep last status after hot reset
Bekijk gratis de handleiding van Advantech PCIE-1824, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCIE-1824 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2250 MB |
