Advantech PCI-1742U handleiding
Handleiding
Je bekijkt pagina 34 van 58
PCI-1742U User Manual 28
• If you have to place your signal cable parallel to a power line that has a
high voltage or high current running through it, try to keep a safe dis-
tance between them. Or, you should place the signal cable at a right
angle to the power line to minimize the undesirable effect.
The signals transmitted on the cable will be directly affected by the qual-
ity of the cable. In order to ensure better signal quality, we recommend
that you use the PCL-10168 shielded cable.
3.6 BoardID Switch Settings
The PCI-1742U card has one Board ID switch setting. The following
image shows the layout of PCI-1742U
:
Figure 3.7: Jumpers and Switch Locations
The PCI-1742U has a built-in DIP-switch (SW1), which is used to define
each the BoardID. You can determine the BoardID switch on the register.
When there are multiple cards on the same chassis, this BoardID switch
setting function is useful for identifying each card device number through
BoardID switch. The factory setting for the PCI-1742U BoardID switch
is 0. If you need to adjust it to other BoardID switchs, set SW1 while
referring to Table 3.2.
Bekijk gratis de handleiding van Advantech PCI-1742U, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCI-1742U |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5110 MB |
