Advantech PCI-1723 handleiding
Handleiding
Je bekijkt pagina 21 van 30
15 PCI-1723 User Manual
Chapter 3 Signal Connections
3.2.1 Board ID (SW1)
The PCI-1723 has a built-in DIP switch (SW1), which is used to define each card’s
board ID. When there are multiple cards on the same chassis, this board ID switch is
used to set each card’s device number.
After setting each PCI-1723, you can identify each card in system with different
device numbers. The default value of board ID is 0 and if you need to adjust it to
another value, please set the SW1 by referring to Table 3.1 below.
Default Setting is 0.
3.2.2 Power On Configuration(JP9)
Default configuration after power on, and hardware reset is to set all the analog input
and analog output channels to open status (output voltage equals zero) so that exter-
nal devices will not be damaged when the system starts or resets. When the system
is hot reset, then the status of isolated digital output channels are selected by jumper
JP9. Table 3.2 shows the possible configurations of jumper JP9.
3.2.3 Current output range jumper
Output range of a channel is configured by a jumper. JP1 through JP8 correspond to
analog output channels 0 through 7.
Table 3.1: SW1
1 2 3 4 Board ID
ON ON ON ON 0
ON ON ON OFF 1
ON ON OFF ON 2
ON ON OFF OFF 3
ON OFF ON ON 4
ON OFF ON OFF 5
ON OFF OFF ON 6
ON OFF OFF OFF 7
OFF ON ON ON 8
OFF ON ON OFF 9
OFF ON OFF ON 10
OFF ON OFF OFF 11
OFF OFF ON ON 12
OFF OFF ON OFF 13
OFF OFF OFF ON 14
OFF OFF OFF OFF 15
Table 3.2:
JP9 Description
(1:2) Keep last status after hot reset
(2:3) Not keep last status after hot reset
JP1 – JP8 Description
(1:2) 4 ~ 20 mA
(2:3) 0 ~ 20 mA
Bekijk gratis de handleiding van Advantech PCI-1723, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCI-1723 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2473 MB |
