Advantech PCE-5033 handleiding
Handleiding
Je bekijkt pagina 17 van 106
9 PCE-5133/5033 User Manual
Chapter 1 Hardware Configuration
1.8 Jumper Settings
This section provides instructions on how to configure your motherboard by setting
the jumpers. It also includes the motherboard’s default settings and your options for
each jumper.
1.8.1 How to Set Jumpers
You can configure your motherboard to match the needs of your application by set-
ting the jumpers. A jumper is a metal bridge that closes an electrical circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To “close” (or turn ON) a jumper, you connect the pins
with the clip. To “open” (or turn OFF) a jumper, you remove the clip. Sometimes a
jumper consists of a set of three pins, labeled 1, 2 and 3. In this case you connect
either pins 1 and 2, or 2 and 3. A pair of needle-nose pliers may be useful when set-
ting jumpers.
1.8.2 BIOS CMOS (JCMOS1)
The SBC CPU card contains a jumper that can erase BIOS CMOS/ME data and
reset the system BIOS information. Normally this jumper should be set with pins 1-2
closed. If you want to reset those data, set JCMOS1/JME1 to 2-3 closed for just a few
seconds, and then move the jumper back to 1-2 closed. This procedure will reset the
CMOS/ME to its last status or default setting.
Table 1.3: JCMOS1/JME1: Clear CMOS/ME Data
Function Jumper Setting
*Keep BIOS CMOS/ME data
Clear BIOS CMOS/ME data
* default setting
1
1-2 closed
2-3 closed
Bekijk gratis de handleiding van Advantech PCE-5033, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | PCE-5033 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19454 MB |
