Advantech MIO-5393 handleiding
Handleiding
Je bekijkt pagina 20 van 96
MIO-5393 User Manual 12
2.4 Setting Jumpers
You may configure your card to match the needs of your application by setting jump-
ers. A jumper is a metal bridge used to close an electric circuit. It consists of two
metal pins and a small metal clip (often protected by a plastic cover) that slides over
the pins to connect them. To “close” a jumper, you connect the pins with the clip. To
“open” a jumper, you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2, or 2 and 3.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes. Generally, you
simply need a standard cable to make most connections.
2.4.1 Clear CMOS (J1)
2.4.2 Auto Power On Setting (J2)
closed 2-3closedopen
Table 2.3: Clear CMOS (J1)
Setting Function
(1-2)* Normal (*Default)
(2-3) Clear COMS
Table 2.4: Auto Power On Setting (J2)
Setting Function
NC Power Button for Power On
(1-2)* Auto Power On (*Default)
Bekijk gratis de handleiding van Advantech MIO-5393, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | MIO-5393 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8579 MB |
