Advantech ITA-5231 handleiding
Handleiding
Je bekijkt pagina 18 van 94
ITA-5231 User Manual 8
2.1 Introduction
The following sections show the internal jumper settings and external connector pin
assignments for system configuration according to applications.
2.2 Jumpers and Connectors
2.2.1 Jumper Description
ITA-5231 can be configured for specific applications by setting jumpers. A jumper is a
metal bridge used to close an electric circuit. It consists of two metal pins and a small
metal clip (often protected by a plastic cover) that slides over the pins to connect
them. To close a jumper, remove the clip. Some jumpers may have three pins,
labelled 1, 2, and 3. For these jumpers, connect either Pins 1 and 2, or Pins 2 and 3.
Open Closed 2-3 Closed
The jumper settings are schematically depicted in this manual as shown below.
Open Closed 2-3 Closed
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
concerns about the best hardware configuration for your application, contact your
local distributor or sales representative before making any changes. For most con-
nection, only a standard cable is required.
12
12
1 23
Bekijk gratis de handleiding van Advantech ITA-5231, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | ITA-5231 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16020 MB |
