Advantech ITA-360L handleiding
Handleiding
Je bekijkt pagina 3 van 27
ITA-360 Startup Manual 3
Power Connector Denition
The IPC has a 4-channel Phoenix power input connec-
tor, which provides 9 ~ 36 V DC voltage to the board. The
denition is as follow:
Phoenix Connecor DC Input
PinDenition
Pin 2/3 Positive
Pin 1/4 GND
DC Power Input Connector
LED Denition
At the top right corner on the rear side, there are 3 LEDs
indicating the operating status.
LED Status
LED Status
Storage LED Orange
Power/Alarm LED Green/Red
Ethernet LED Denition
The IPC has serial RJ45 Ethernet connectors, with LEDs
showing network status.
LAN
LED Status
2500 MB Green (top left LED)
1000 MB Orange (top left LED)
Connection Status Green lckering (top right LED)
RJ45 Connector
ConnectorDenition(Cont.)
1. Read these safety instructions carefully.
2. Keep this User Manual for later reference.
3. Disconnect this equipment from any AC outlet before
cleaning. Use a damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socket must
be located near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installa-
tion. Dropping it or letting it fall may cause damage.
7. Make sure the voltage of the power source is correct
before connecting the equipment to the power outlet.
8. Position the power cord so that people cannot step on
it. Do not place anything over the power cord.
9. All cautions and warnings on the equipment should be
noted.
10. If the equipment is not used for a long time, disconnect
it from the power source to avoid damage by transient
overvoltage.
11. Never pour any liquid into an opening. This may cause
re or electrical shock.
12. Never open the equipment. For safety reasons, the
equipment should be opened only by qualied service
personnel.
13. If one of the following situations arises, get the equip-
ment checked by service personnel:
• The power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• The equipment has been exposed to moisture.
• The equipment does not work well, or you cannot get
it to work according to the user’s manual.
• The equipment has been dropped and damaged.
• The equipment has obvious signs of breakage.
14. Do not leave this equipment in an environment where
the storage temperature may go below -25° C (-13°
F) or above 60° C (140° F). This could damge the
equipment. The equipment should be in a controlled
environment.
15. Caution: Danger of explosion if battery is incorrectly
replaced. Deplace only with the same or equivalent
type recommended by the manufacturer, discard used
batteries according to the manufacturer’s instrcuctions.
16. This equipment has been tested and found to comply
with the limits for Class A digital device. Operation of
this equipment in a residential area is likely to cause
harmful interference to radio communications in which
case the user will be required to correct the interfer-
ence.
17. This equipment is sold without power cord. It is recom-
mended to purchase CCC certicated power cord.
The sound pressure level at the operator’s position accord-
ing to IEC 704-1:1982 is no more than 70 dB (A).
DISCLAIMER: This set of instructions is given according
to IEC 704-1. Advantech disclaims all responsibility for the
accuracy of any statements contained herein.
Safety Instructions
Bekijk gratis de handleiding van Advantech ITA-360L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | ITA-360L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4088 MB |
