Handleiding
Je bekijkt pagina 33 van 41
27 IDK-2115 User Manual
Chapter 5 Touchscreen and Touch Controller
5.2.2.2 Combo Interface Connector, JP1, Pins and Signal Descriptions
The combo interface connector for USB and RS-232 is a 2.0mm, 10-pin, 90 degree
box; male type with lock connector. It is intended to be used with single wired pins in
5+5 pins header. The pins are numbered as shown in the table below.
Figure 5.1 Board Mounted Header
5.2.2.3 Touch Screen Connector, JP2, Pins and Signal Descriptions
The touchscreen connector, JP2, is a single row, 2.54mm, 5-pins, 90 degrees; male
type connector. The pins are numbered as shown in the table below.
USB
Pin #
Signal
Name
Signal Function
RS-232
Pin #
Signal
Name
Signal Function
1 G Ground 1 G Ground
2 V USB Power 2 V Power
3 G Ground 3 G Ground
4 D+ USB D+ 4 TxD Serial Port
5 D- USB D- 5 RxD Serial Port
Signal
Name
DB-9 pin # RS-232 pin # Sourced by Signal Description
RxD 2 5 ctlr serial data from controller to host
TxD 3 4 host serial data from host to controller
JP2 Pin # Signal Name Signal Description
1H / UR
Drive signal attached to the touchscreen substrate upper right
corner when viewed from a user's perspective.
2 Y / UL Drive signal attached to the substrate upper left corner.
3COM-
4 X / LR Drive signal attached to the substrate lower right corner.
5 L / LL Drive signal attached to the substrate lower left corner.
Bekijk gratis de handleiding van Advantech IDK-2115, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | IDK-2115 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 4283 MB |
