Advantech ACP-4010 handleiding
Handleiding
Je bekijkt pagina 17 van 40
9 ACP-4010 User Manual
Chapter 2 System Setup
2.4 Installing CPU Card or Add-on Card
ACP-4010 supports up to 15 cards. To install a CPU card or add-on card, please pro-
ceed as follows:
1. Select a vacant PICMG slot for the full-length CPU card, or a PCI/ISA slot
for other add-on cards. Then, remove the corresponding I/O bracket
attached to the rear plate of the chassis.
2. Insert the CPU card (with CPU, CPU cooler, RAM, and necessary cables
installed) or add-on card vertically into the proper slot. For full-length CPU
cards, please make sure that the card bracket has been inserted properly
into the slot connector. Fasten the screws on the top of both brackets of the
card. (see Figure 2.5)
3. Repeat Step 1 and 2 if there is more than one add-on card to be installed.
4. Connect the 9-pin USB wire, power switch wire and system reset switch wire
from the chassis to the CPU card.
5. Connect the wire of LAN LED and HDD LED from the chassis to the CPU
card.
6. For the PICMG1.0 Backplane, connect the orange-white wire from the con-
nector ‘CN20’ on the CPU card to the connector ‘HCN1’on the backplane.
Connect the 4-pin +12 V power connector from the power supply to the CPU
card.
Figure 2.5: Installing a full-length card
Bekijk gratis de handleiding van Advantech ACP-4010, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advantech |
| Model | ACP-4010 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3543 MB |
