Advance SC450 handleiding
Handleiding
Je bekijkt pagina 19 van 100
INSTRUCTION FOR USE ENGLISH
9099602000 - SC450 17
8/12
RECOVERY TANK REMOVAL
To check or charge the lead (WET) batteries, or to perform other procedures, it may be necessary to remove the recovery tank (16)
as shown below.
1. Empty the recovery tank (16) as shown in the relevant paragraph.
2. Drive the machine on a level oor.
3. Make sure that the switches (41 and 42) are turned to “0”.
4. Remove the recovery water drain hose (11) from its holder.
5. Grasp the recovery tank (A, Fig. 5) in the area (B) and slightly raise it.
6. Disconnect the vacuum hose (C) from the tank.
7. Disconnect the hose (D) from the tank vacuum grid.
8. Remove the drain hose(E) through the slit, then remove the tank (A).
A
B
B
E
C
D
Figure 5
P100665
9. Install the tank by performing steps 4 to 8 in the reverse order of removal.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. Disconnect the battery connector (8).
9099602000(2)04-2014.indb 17 08/04/2014 12:41:42
Bekijk gratis de handleiding van Advance SC450, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advance |
| Model | SC450 |
| Categorie | Boenmachine |
| Taal | Nederlands |
| Grootte | 14230 MB |
