Advance SC351 handleiding
Handleiding
Je bekijkt pagina 22 van 84
ENGLISH INSTRUCTIONS FOR USE
20 SC351 - 9099867000
TROUBLESHOOTING
Trouble Possible Cause Remedy
The motors do not turn on; no LED
turns on.
The battery connector is disconnected. Connect.
The battery is completely discharged.
Contact Advance Service Center to restore the
battery or to replace it.
The fuse F3 is open. Replace.
The brush motor does not run. The F1 fuse has triggered. Reset the fuse.
The vacuum system motor does not
turn on.
The fuse F2 is open. Replace.
The dirty water vacuuming is
insufcient.
The recovery tank is full. Empty.
The vacuum grid is clogged or the oat is stuck
closed.
Clean the grid and check the oat.
The vacuum hose is disconnected from the squeegee
or faulty.
Connect or replace. (*)
The squeegee is dirty or the squeegee blades are
worn or damaged.
Clean the squeegee or replace the blades.
The recovery tank cover is not properly closed, or the
gaskets are damaged.
Check and/or clean the seating surface or replace
the gaskets.
The vacuum system motor lter is dirty. Clean.
The solution ow is insufcient.
The detergent duct is dirty/clogged. Clean.
The solenoid valve is faulty. Replace. (*)
The squeegee leaves marks on the
oor.
There is debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or torn. Replace the blades.
When connecting the battery charger
to the electrical mains the 3 LEDs on
the handlebar turn on and the battery
does not charge.
The battery is damaged or it is excessively
discharged.
Contact Advance Service Center to restore the
battery or to replace it.
When connecting the battery charger
to the electrical mains the yellow LED
on the handlebar ashes and the
battery does not charge.
The battery is not properly connected to the machine
system.
Check the battery connections.
When connecting the battery charger
to the electrical mains the red LED on
the handlebar ashes and the battery
does not charge.
There is a fault in the battery charger. Replace. (*)
When the battery charging procedure
is completed, the red LED on the
handlebar ashes.
The battery has not been fully charged during the
maximum time interval allowed.
Try to repeat the battery charging procedure.
If the problem persists, replace the battery.
(*) This maintenance procedure must be performed by an authorised Advance Service Center.
NOTE
The machine is inoperative without the battery charger.
In case of battery charger malfunction, contact an authorised Service Center.
For further information, refer to the Service Manual, available at any Advance Service Center.
SCRAPPING
Have the machine scrapped by a qualied scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Battery
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
9099867000(2)2013-03.indb 20 29/11/2013 11:31:27
Bekijk gratis de handleiding van Advance SC351, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advance |
| Model | SC351 |
| Categorie | Boenmachine |
| Taal | Nederlands |
| Grootte | 12594 MB |
