Advance Adfinity X20C handleiding
Handleiding
Je bekijkt pagina 27 van 124
INSTRUCTIONS FOR USE
9096910000(1)2006-09 25
VACUUM SYSTEM MOTOR FILTER CLEANING
1. Drive the machine on a level floor.
2. Turn the ignition key (80) to “0” position.
3. Open the recovery water tank.
4. If necessary, drain the water from the tank in order to make the filter visible.
5. Check that the pre-filter is clean. If necessary clean it with water and compressed air, then install it.
6. Carry out steps 1, 2 and 3 in the reverse order.
SOLUTION FILTER CLEANING
(For 20D)
1. Drive the machine on a level floor.
2. Turn the ignition key (80) to “0” position.
3. Close the solution tap (A, Fig. 8) under the machine, behind the right rear wheel. The tap (A) is closed when it is on the
position (B) and it is open when it is on the position (C).
4. Remove the transparent cover (D), then remove the filter strainer (E). Clean and install them on the support (F).
5. Open the tap (A).
S311322
Figure 8
NOTE
The filter strainer (E) must be correctly positioned on the housing (G) of the support (F).
E
G
B
A
D
C
F
E
Bekijk gratis de handleiding van Advance Adfinity X20C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Advance |
| Model | Adfinity X20C |
| Categorie | Boenmachine |
| Taal | Nederlands |
| Grootte | 15444 MB |
