Adler AD 6810 handleiding
Handleiding
Je bekijkt pagina 6 van 76
6
carried out in the company of at least two people.
17. Residues of the working substance should be diluted and used on
previously sprayed surfaces.
18. The working liquid should not get into open water.
19. After finishing work, the sprayer should be emptied and washed with clean
water.
20. After finishing work with harmful chemicals, thoroughly wash the entire
body.
21. Keep the sprayer, and all its equipment, packaging and chemicals out of the
reach of children.
22. It is recommended that each time, put the name of the chemical used on the
tank. A marker can be used for this.
23. A sprayer that is not suitable for further use should be washed and taken to
a waste disposal facility.
Safety instructions
1. Never open under pressure.
2.Never unscrew the nozzle(1) under pressure.
3.After use, release the pressure by lifting the safety valve and clean the tank, then flush the nozzle(1) and tank(8) with
water.
4. Do not pour the residual working fluid into the drain.
5. Do not pour liquid below 0 degrees Celsius or above 30 degrees Celsius into the tank.
6. Do not pour corrosive liquids into the tank, the tank is designed to be filled with liquids in the pH range of 5-10.
Description:
1.Adjustable spray nozzle
2.Nozzle connector
3.Trigger
4.Lance
5.Pressure hose
6.Pressure pump rod
7.Air chamber pressure cover
8.Tank
9.Tank cover
10.Tank handle
11.Backpack harness
Application:
1.Attach the hose(5) with the spray lance(4) and tank(8) by screwing it in a clockwise direction. Look at figure 1.
2.Unscrew the tank lid(9) counterclockwise(do not remove the filler strainer) and pour in the required amount of spray
liquid Look at figure 2-3.
3.Screw off the lid(9), making sure that the vent valve is in working order. Look at figure 4.
4.Before spraying, adjust the backpack harness(11) to the proper length.
5.Press the pressure pump rod(6) 6-8 times. Increase the pressure by sucking in the working fluid (maximum pressure
3.0Bar). Look at figure 5.
6.Adjust the nozzle(1) as needed (mist or jet). Press lance trigger(3) to start application. Look at figure 6.
7.To spray continuously, when pressed, move the trigger(3) forward to the locked position. To unlock, move the
trigger(3) backward. See figure 6B.
Maintenance: 3 spare rubber gaskets included.
Troubleshooting:
Bekijk gratis de handleiding van Adler AD 6810, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adler |
| Model | AD 6810 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8584 MB |
