Adj Vizi Beam 5RX handleiding
Handleiding
Je bekijkt pagina 20 van 33
20
SYSTEM MENU
ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until “ADDR” is displayed, then press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER to set your desired DMX address.
CHND - This will let select your desired DMX channel mode.
1. Press the MENU button until “CHND” is displayed, press ENTER. Either “16CH” or “19CH” will be
displayed
2. Press the UP or DOWN buttons to find your desired DMX channel mode, and press ENTER to
confirm and exit.
IPAN - Pan Inversion
1. Press the MENU button until “IPAN” is displayed, press ENTER. Either “Yes” or “No” will be
displayed.
2. To activate the Pan inversion, press the UP or DOWN buttons until “Yes” is displayed, then press
ENTER to confirm. To deactivate Pan inversion, select “No” and press Enter.
ITLT - Tilt Inversion
1. Press the MENU button until “ITLT” is displayed, press ENTER. Either “Yes” or “No” will be
displayed.
2. To activate the tilt inversion, press the UP or DOWN buttons until “Yes” is displayed, then press
ENTER to confirm. To deactivate tilt inversion, select “No” and press Enter.
LED - With this function you can have the display backlight turn off after 10 seconds.
1. Press the MENU button until “LED” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” to keep
the LED display on at all times, or “OFF” to switch to have the LED display switch off after 10
seconds.
3. Press ENTER to confirm. To make you LED display reappear again press any button.
DISP - This function will reverse the display 180º.
1. Press the MENU button until “DISP” is displayed, press ENTER.
2. Press ENTER to “flip” the display. Press ENTER to “flip” it again. Press ENTER when you have
made your desired setup.
TEST - This function will run a self test program.
1. Press the MENU button until “TEST” is displayed, press ENTER.
2. The fixture will now run a self test.
FHRS - This serves two functions; displays the lamp running time and clears the lamp running
time. The lamp running time needs to be cleared after a new lamp has been installed.
1. Press the MENU button until “FHRS” is displayed, press ENTER.
2. The lamp running time will now be displayed. Press MENU to exit.
3. To clear the lamp running time, press the ENTER button when lamp running time is displayed.
Either “NO” or “CLea” will be displayed.
4. Use the UP or DOWN buttons to select “CLea” and press ENTER. “0” should be flashing on the
display. At this time, press the UP button until “50” is displayed, and press ENTER. The lamp
running time will now be cleared. Press MENU to exit. You should clear the lamp running time
every time you change the lamp.
Bekijk gratis de handleiding van Adj Vizi Beam 5RX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Vizi Beam 5RX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6901 MB |
