Adj Vizi Beam 5RX handleiding
Handleiding
Je bekijkt pagina 17 van 33
17
SETUP
Power Supply: The ADJ® Vizi Beam 5RX contains a electronic ballast, which will auto sense the
voltage when it is plugged into the power source. With the electronic ballast you do not need to worry
about wall voltage, this unit can be plugged in anywhere.
DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used as a form of communication
between intelligent xtures and controllers. A DMX controller sends DMX data instructions from the
controller to the xture. DMX data is sent as serial data that travels from xture to xture via the DATA
“IN” and DATA “OUT” XLR terminals located on all DMX xtures (most controllers only have a DATA
“OUT” terminal).
DMX Linking: DMX is a language allowing all makes and models of different manufactures to be
linked together and operate from a single controller, as long as all xtures and the controller are DMX
compliant. To ensure proper DMX data transmission, when using several DMX xtures try to use the
shortest cable path possible. The order in which xtures are connected in a DMX line does not inuence
the DMX addressing. For example; a xture assigned a DMX address of 1 may be placed anywhere in
a DMX line, at the beginning, at the end, or anywhere in the middle. When a xture is assigned a DMX
address of 1, the DMX controller knows to send DATA assigned to address 1 to that unit, no matter
where it is located in the DMX chain.
Data Cable (DMX Cable) Requirements (For Standard DMX Operation or Primary/Secondary
Operation): The Vizi Beam 5RX can be controlled via DMX-512 protocol. The Vizi Beam 5RX can be
either a 16 or 19 channel DMX unit. The DMX address is set electronically using
the controls on the side panel of the unit. Your unit and your DMX controller
require an approved DMX-512 110-Ohm Data cable for data input and data
output as seen on the right. We recommend Accu-Cable DMX cables. If you are
making your own cables, be sure to use standard 110-120 Ohm shielded cable
(This cable may be purchased at almost all professional sound and lighting
stores). Your cables should be made with a male and female XLR connector on
either end of the cable. Also remember that DMX cable must be daisy chained
and cannot be split.
Notice: Be sure to follow the gures below when making your own cables. Do
not use the ground lug on the XLR connector. Do not connect the shield of the cable conductor to the
ground lug, or allow the shield conductor to come in contact with the outer casing of the XLR. Grounding
the shield could cause a short circuit and erratic behavior.
Bekijk gratis de handleiding van Adj Vizi Beam 5RX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Vizi Beam 5RX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6901 MB |
