Adj Mega QA Go handleiding
Handleiding
Je bekijkt pagina 20 van 25
Battery Status:
This function is used to check the life status of the battery. Plug the xture in and press the MODE
button until “bXXX” is displayed. “XXX” represents an number between “000” and “100”. The number
that is displayed is the remaining battery life. If “b---” is displayed, it means the battery is dead or you
are running the unit on AC power. Please do not let the battery fully die, this severely shortens the
life of the battery.
Example: If “b050” is displayed, the battery is at half life. If “b025” is displayed, the battery is at 25% life.
NOTE: When the battery is charging or if the battery life is below 30% the digital display will ash.
NOTE: After 20 seconds of inactivity, the display will revert back to the battery life display.
Battery Recharge: To recharge the battery, plug the supplied AC cord into the AC input on the side of
the unit and plug the other end into a matching power supply. It takes about 4 hours to reach full charge.
The display will STOP ashing when the unit reaches 100% charge.
Note: When unplugging the unit from charging and then applying power via battery, there will
be a minimal charge drop.
For a faster recharge, put the Load Switch in the “Off” position and the Battery Switch in the “ON” position.
Mega QA Go Battery Status & Recharge
Mega QA Go Photometric Chart
ADJ Products, LLC — www.adj.com — Mega QA Go - User Manual — Page 20
Bekijk gratis de handleiding van Adj Mega QA Go, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Mega QA Go |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3132 MB |
