Adj LED UV GO handleiding
Handleiding
Je bekijkt pagina 4 van 8
ADJ Products, LLC - www.adj.com - LED UV GO Instruction Manual Page 6 ADJ Products, LLC - www.adj.com - LED UV GO Instruction Manual Page 7
LED UV GO System Menu
BLND - This will control blackout
1. Press the MENU button until “BLND” is displayed, press
ENTER.
2. Either “YES” or “NO” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. Press ENTER, and then press and hold the MENU button for at
least three seconds to conrm.
LED - With this function the LED display will turn off after
2 minutes.
1. Press the MENU button until “LED” is displayed, press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to allow the LED display to turn o after 2 min-
utes. Press any button to turn on the LED display again.
3. Press ENTER, and then press and hold the MENU button
for at
least three seconds
to conrm.
DISP - This will “ip” the LED display
1. Press the MENU button until “DISP” is displayed, press
ENTER.
2. When “DISP” is displayed the LED display will remain normal,
when “DSIP” is displayed, the LED display will be “ipped”.
Use the ENTER button to nd your desired display set up, then
press MENU to conrm and exit.
BATT - This function is used for checking the battery
status and battery charging.
1. Press the MENU button until “BATT” is displayed, press
ENTER.
LED UV GO System Menu
DIMM - Dimmer Mode
1. Press the MENU button until “DINN” is displayed, press
ENTER.
2. “dXXX” will now be displayed, “XXX” representing a number
between 0-255. Use the UP of DOWN buttons to adjust the
output intensity.
3. Once you have found your desired intensity, press ENTER to
conrm.
STRO - Strobe mode
1. Press the MENU button until “STRO” is displayed, press
ENTER.
2. “SP X” will now be displayed, “X” representing a number
between 1-9. These are the strobe speeds, 1 being the slowest,
and 9 being the fastest. Use the UP and DOWN buttons to adjust
the strobe speed.
3. Press ENTER to conrm.
On-Board System Menu.
The LED UV GO comes with an easy to
navigate system menu. This next section will detail the functions of
each command in the system menu. Please read the next section
thoroughly!
To access the main menu press the MENU button. Tap the UP or
DOWN buttons until you reach function you wish to change. When you
reach the function you wish to change press the ENTER button. When
a function is selected use the UP or DOWN buttons to change the func-
tion settings. Once your changes are made press the ENTER button,
and then press and hold the MENU button for at least three seconds
to conrm and lock the change into the system memory. If the MENU
button is not pressed and held within eight seconds the xture will
automatically conrm and lock the change into the system memory. To
exit without making any changes press the MENU button.
Bekijk gratis de handleiding van Adj LED UV GO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | LED UV GO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1327 MB |
