Adj Inno Beam LED handleiding
Handleiding
Je bekijkt pagina 8 van 16
ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 16ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 15
3. Press ENTER to set you desired level.
Pan Invert - Pan Inversion
1. Press the MENU button until “Pan Invert” is displayed, press
ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “Yes” is displayed, press ENTER to conm. To deactivate
Pan inversion, select “No” and press Enter.
Tilt Invert - Tilt Inversion
1. Press the MENU button until “Tilt Invert” is displayed, press
ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until “Yes” is displayed, press ENTER to conm. To deactivate
Tilt inversion, select “No” and press Enter.
Back Light - With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until “Back Light” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the backlight on at all
times, or “OFF” to allow the backlight to turn o after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to conrm.
Dimmer Calibrat - With this function you can set the
output intensity.
1. Press the MENU button until “Dimmer Calibrat” is displayed,
press ENTER.
2. A number between 50-100 will be displayed. This number rep-
Inno Beam LED System Menu Inno Beam LED System Menu
resents the instensity setting. Use the UP or DOWN buttons to
adjust the LED output intensity. 50 being medium intensity, and
100 being full intensity.
3. When you have found your desired setting press ENTER to
conrm.
Auto Test - This function will run a self test program.
1. Press the MENU button until “Auto Test” is displayed, press
ENTER.
2. The xture will now run a self test. Press the MENU button to
exit.
Fixture Temp. - With this function you can display the
running temperature of the unit.
1. Press the MENU button until “Fixture Temp.” is displayed,
press ENTER.
2. The current running temperature of the xture will now be
displayed. Press MENU to exit.
Fixture Time - With this function you can display the
running time of the unit.
1. Press the MENU button until “Fixture Time” is displayed,
press ENTER.
2. The running time of the xture will now be displayed. Press
MENU to exit.
Firmware Version - This will display the software ver-
sion
1. Press the MENU button until “Firmware Version” is displayed.
Press the ENTER button and the software vesion will be dis-
played.
Bekijk gratis de handleiding van Adj Inno Beam LED, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Adj |
| Model | Inno Beam LED |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2343 MB |
