ADB Eurodim Twin Tech handleiding
Handleiding
Je bekijkt pagina 66 van 96
EURODIM TWIN TECH
Page 64 sur 92
7.9.5 Loads Scanning Menu - Scan
Important: this function works if the sequential diagnostic kit has been installed in the cabinet. In effect, it
is used to measure the neutral current on the module power line (busbar).
This function is used to launch a test verify the loads present at the output of each circuit using a current
measurement in relation to the loads provided by the "Load verification – Learn" menu.
7.9.5.1 Selecting the outputs to be scanned
There are several ways to manually select the outputs that we wish to scan:
− By touching the module/dimmer number,
− By selecting the row using the wheel by pressing down,
− By positioning on the row using the wheel and by pressing key 1 to select (press key 0 to deselect)
A validation symbol appears in front of the module/dimmer number.
Important note: It is not possible to select a sinewave or FLUO module circuit for the scan (see status).
A circuit cannot be selected if the switch law is applied (see information in Status)
because in this case, this circuit’s load is not dimmable
Manual
selection = √
Bekijk gratis de handleiding van ADB Eurodim Twin Tech, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ADB |
| Model | Eurodim Twin Tech |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 19177 MB |
