ADB Eurodim Twin Tech handleiding
Handleiding
Je bekijkt pagina 27 van 96
EURODIM TWIN TECH
Page 25 sur 92
− SETTINGS: Human-Machine interface configuration
− SCAN LOAD: to measure/scan the loads connected at the outputs of each circuit
− MOD. MEAS.: gives the voltage and current measurements for each circuit
− MOD. DIAG: gives the diagnosis of the outputs of each module
− ENET PATCH: to edit the patch of the three ARTNET or sACN universes for each circuit
− ENET INFO: general information on the ARTNET/sACN universes and the Ethernet connection
− ENET SET.: to configure the three ARTNET/sACN universes, the IP address and the RDM.
− SERVICE: function available to ADB technical service only
− SYNCHRO: to synchronise the parameters recorded between each of the controllers
Note: All the information displayed in the different menus originates from controller 1 if two controllers
are present in the cabinet.
If only controller 2 is present, all the information displayed in the different menus will originate
from the latter. When changing the patch, power multiplication factor, law... the new data is sent
to each controller. The circuits defined as « empty slot » or « undefined slot » are not editable and
not visible in any screens. It appears again when the circuit will not be declared as “empty slot” or
“undefined slot”.
7.1 PATCH MENU
This function is used to configure a patch on a circuit or set of circuits for the DMX A and DMX B signal.
This configuration enables the user to attribute the value of a DMX A and DMX B signal channel to the
control of one of the cabinet’s circuits.
Bekijk gratis de handleiding van ADB Eurodim Twin Tech, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ADB |
| Model | Eurodim Twin Tech |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 19177 MB |
