Handleiding
Je bekijkt pagina 29 van 40
If the range has accessories that need a power supply, make
sure the installation is close from a wall outlet.
The plug has to be connected to a power supply of 105 - 140 V
~. Make sure the installation is properly grounded.
When the gas installation is done, connect the range to the
electric supply.
Accessory Installation
Installation of back panel (in some models.)
If your appliance is equipped with a back panel, follow these steps for installation:
1. Remove the packaging materials from the back panel of the range.
2. You will find 2 bolts and a bag with the installation (2 screws with 2 butterfly nuts and 4 standard
screws) taped to the back of the back panel.
3. Put the back panel over the cooktop, slide it until the back end, check the screw holes of the
panel and the cooktop are aligned.
4. Put the 2 screws (B) with the 2 butterfly nuts (A) following the image above.
5. Locate the supporting brackets, place one by one and screw the 4 standard screws (C) using a
Phillips screwdriver following the image above.
Testing your Range
Once the range has been installed, it’s necessary to test the correct installation of the gas and power supply. For this, place the range on
its final location and turn on the cooktop burners and the oven.
Cooktop burners
Depending on the model of your range, the appliance may have 1 step or 2 step electronic ignition. Follow this sequence to test the
electronic ignition:
Electrical Requirements
WARNING
Electrical Shock Hazard
Do not use an extension cord.
Don´t use the product without ground prong.
Don´t use universal plugs.
Unplug the power supply before giving maintenance.
Do not remove ground prong.
Failure to follow these instructions can result in death, fire,
or electrical shock.
The supporting bracket should
be in this position for a correct
installation on the back panel.
A. Butterfly nuts
B. Screws
C. Screws
D. Supporting brackets
next to the cooktop controls to the Hi position
Ranges with 2 step electronic ignition:
If your range has the electronic ignition button: press and hold the button with the image
(maximum flame). See the following image.
You will hear a click, this is the spark’s noise, it will light up the flame, once it is on, release the button.
The spark will ignite and the flame will be on the Hi setting (maximum). Once the burner is lighted, set the knob on the desired position.
The same procedure can be followed to light up the other burners.
Electronic ignition button
29
Bekijk gratis de handleiding van Acros AF5431B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Acros |
| Model | AF5431B |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 9551 MB |
Caratteristiche Prodotto
| Soort bediening | Draaiknop |
| Kleur van het product | Zwart |
| Ingebouwd display | Nee |
| Breedte | 795 mm |
| Diepte | 580 mm |
