ACR G406-4 handleiding
Handleiding
Je bekijkt pagina 34 van 70
ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
G406-4 (453-5012)
570-5012 Rev. P Company Confidential 25-62-21 Page 34 of 70
SUBTASK 25-62-21-750-011
P. Installed Transmitter Test – Item 6
CAUTION: DO NOT ALLOW THE DURATION OF THIS TEST TO EXCEED 5 SECONDS. THE ELT
WILL TRANSMIT A 406 MHZ SIGNAL AFTER THE ELT IS ACTIVATED FOR
APPROXIMATELY 47 SECONDS. THE COSPAS-SARSAT SATELLITE SYSTEM WILL
CONSIDER THE 406 MHZ TRANSMISSION TO BE A VALID DISTRESS SIGNAL.
1) Reinstall the ELT in accordance with SUBTASK 25-62-21-410-001 on page 56.
2) Perform the following functional check within the first 5 minutes after the hour (UTC), as required by
AC 43.13-1, Chapter 12, § 12-22, Note 3.
3) Notify any nearby control tower of your intentions.
4) Tune a receiver, usually the aircraft transceiver, to 121.5 MHz.
NOTE: An AM radio may be used to receive the signal.
5) Activate the ELT by placing the cockpit remote switch in the “ON” position. The LED will begin
flashing continuously.
6) Listen for 3 audible sweeps on the receiver, which takes about 1 second.
7) Verify the buzzer sounds immediately upon activation.
8) Return the cockpit remote switch to the “ARM” (OFF) position while paying close attention to LED
activity when the ELT enters the “ARM” condition. If the ELT is working properly, the LED will stay on
for approximately 1 second and then turn off.
NOTE: This test also completes the requirement to check ELT controls by verifying operation
of the remote switch.
9) Refer to Table 6 on page 36 if the LED displays a series of error code flashes.
Bekijk gratis de handleiding van ACR G406-4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ACR |
| Model | G406-4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8218 MB |
