ACR C406-2 handleiding
Handleiding
Je bekijkt pagina 40 van 66
ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
C406-2 (453-5000), C406-2HM (453-5001)
570-5000 Rev. V Company Confidential 25-62-11 Page 40 of 66
1) All installations must be performed in accordance with Canadian Aviation Regulations (CAR) Part V,
Chapter 551, Paragraph 551.104.
SUBTASK 25-62-11-990-004
E. Other Countries
1) Installations in aircraft outside of the United States and Canada, must be performed in accordance
with applicable regulatory authority rules and regulations.
SUBTASK 25-62-11-990-005
F. RTCA
1) DO-204, § 3.1.8 guidelines for mounting a ELT:
a) The ELT shall be mounted to primary aircraft load carrying structures, such as trusses,
bulkheads, longerons, spars, or floor beams.
b) The mounts shall have a maximum static local deflection no greater than 0.1 inches (2.5 mm)
when a force of 100 lbs (450 newtons) is applied to the mount in the most flexible direction.
Deflection measurements shall be made with reference to another part of the aircraft not less
than 1 foot (0.3 meters) nor more than 3 feet (1.0 meters) from the mounting location.
2) DO-182, § 6.2.2.b recommends that:
a) To maximize the probability of the ELT transmitting a detectable signal after a crash, all ELT
system components, which must survive a crash intact, e.g. transmitter and external antenna,
should be attached to the airframe in such a manner that the attachment system can support a
100
g
load, (ELT weight x 100, ELT antenna weight x 100, etc.) applied through the center of
gravity of the component (ELT, antenna, etc.) in the plus and minus directions of the three
principal axes of the aircraft.
b) Post-crash critical components of the ELT system, e.g., transmitter and external antenna, should
be mounted as close to each other as possible.
c) The antenna coax cable should not cross any production breaks, e.g., major structure sections,
such that the ELT and antenna are in the same section of the aircraft and as close together as
possible.
d) If the ELT and external antenna are on opposite sides of an airframe production break, the
components should be secured to each other by a tether that can support a 100
g
load (ELT
weight x 100). The interconnecting antenna-to-ELT coax cable should have sufficient slack on
both ends that it will not be subjected to any tensile load and should be tied loosely to the tether.
Bekijk gratis de handleiding van ACR C406-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ACR |
| Model | C406-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7243 MB |
